We are proud to finally release our V1 Exhaust system. A couple of you already have this and have been enjoying the beautiful sound it makes.
We set out to make one of the highest quality systems available that was simple and had a great sound. We have a single piece mid pipe section that is mandrel bent as needed and one of the straightest available. A V-Band clamp was used to attach the axle back portion for ease of install, and future V2 and V3 upgrade options.
The sound is awesome, and really lets the boxer rumble out. There is no drone at highway speeds and quiets right down when cruising. We have videos at the bottom of the thread as usual to show off sound outside and inside the car. You hear the exhaust when you want to, by letting the RPM’s wrap out with your foot firmly on the floor, and don’t hear it when cruising at 3000 RPM down the highway. It is also not overly loud when shifting normally on your morning commute to work.
If you are looking for something made in the USA, that’s extremely high quality and provides a great sound, then this is it.
2.5″ T304 Stainless Catback to Mufler
Minimal bends, Single Peice Mid-Pipe No pie cuts and welds here.
4″ Stainless Angle Cut tips
Made in the U.S.A
V-Band Clamp for rear section
Up to a 7 Wheel HP Gain in the RPM range
Up to a 3 FT LB in Torque Gain in the RPM range
Doesn’t annoy the Girlfriend / Wife
Videos with different front pipes. Please check the text above the video to know which pipe it is.
Rev – Stock Front Pipe:
Drive By – Stock Front Pipe:
In Car – Stock Front Pipe:
Launch – Stock Front Pipe:
Exterior Stationary Rev with Invidia Catless Front Pipe
Exterior Drive By’s with Invidia Catless Front Pipe
In Car with Invidia Catless Front Pipe